– The firing strength could be too low/high:
1.Perform a test fastening procedure using the lowest permissible cartridge and firing strengths.
2.If the nail does not penetrate far enough into the material: Gradually increase the firing strength.
3.If the nail does not penetrate deep enough into the material in spite of having set the highest firing strength: Insert a cartridge with a higher strength rating and repeat the test fastening procedure - start with the lowest firing strength again.
4.Setting the firing strength on the adjustment wheel: Increase: turn in “+” direction, Decrease: turn in “-“direction.
– The nails may be too long/too short for the base material, please refer to the base material table below
Recommended base material Recommended pin penetration
Mild Steel 10mm
Please note fixture thickness and add above
– If the Cartridge Tool has to be serviced, take it to be repaired by an authorized service agent.
PLEASE NOTE - If the nail gun does not fire immediately after pressing the trigger, keep the Tool pressed against the work surface for at least another 30 seconds.